Imron Corporation

VertX FEATURES:

Web Browser accessible – No loading of administration software on a computer
No dedicated computer required
The IS100 Web Application resides in the VertX controller
Manage up to 5,000 Card Holders per Controller
Up to 64 Readers per controller
128-bit security encryption to protect your system data
Manage up to 20 Network IP Cameras
Simplistic installation, setup and system administration
Minimal instruction and reduced training time
Cost effective solution for many applications

VertX HARDWARE

	VertX ACCESS CONTROL HARDWARE The VertX products provide a complete and fully featured hardware/firmware infrastructure for access control software host systems. IS100 Product Brochure
	V1000 The V1000 can communicate via industry standard TCP/IP protocol, over 10/100 Mbps Ethernet or the Internet and has a 32-bit RISC processor. On-board flash memory allows program updates to be downloaded via the network. The V1000 connects up to 32 Door/Reader, Input Monitor, or Output Control sub-controllers via two independent RS-485 networks, each network having two sets of input connections for optimum system topology. This architecture minimizes the impact on corporate LANs by using only one TCP/IP address for every 32 sub-controllers and by handling low-level transactions on the RS-485 network. Datasheet
	V2000 The V2000 can communicate via industry standard TCP/IP protocol, over 10/100 Mbps Ethernet or the Internet and has a 32-bit RISC processor. On-board flash memory allows program updates to be downloaded via the network. The V2000 connects to two access control card readers via Wiegand or Clock-and-Data interface controlling either one or two doors. This architecture takes advantage of the existing corporate LAN and the existing CAT-5 cable. Datasheet
	V100 The V100 Door/Reader Sub-Controller connects two access control card readers via Wiegand or Clock-and-Data interface controlling either one or two doors. The V100 features on-board flash memory allowing program updates to be downloaded via the network. The V100 connects to the V1000 through a high speed RS-485 network. The V1000, in turn, communicates with the system host via industry standard TCP/IP protocol over 10/100 Mbps Ethernet or the Internet. This architecture minimizes the impact on corporate LANs by using only one TCP/IP address for every 32 sub-controllers and by handling low-level transactions on the RS-485 network. Datasheet
	V200 The V200 Input Monitor Sub-Controller connects up to 16 supervised input circuits. Each input point monitors and reports normal, off-normal, and alarm states. The V200 features on-board flash memory, allowing program updates to be downloaded through the network. The V200 connects to the V1000 via a high speed RS-485 network. The V1000, in turn, communicates with the system host via industry standard TCP/IP protocol, over 10/100 Mbps Ethernet, or the Internet. This architecture minimizes the impact on corporate LANs, by using only one TCP/IP address for every 32 sub-controllers and by handling low-level transactions on the RS-485 network. Datasheet
	V300 The V300 Output Control Sub-Controller contains 12 latching Form-C relays, which can connect up to 12 devices controllable by simple contact closures, such as logic inputs for process equipment, HVAC and elevator control panels, CCTV switchers, etc. Loads exceeding 2 A @ 30 VDC should be controlled via interposing relays. The V300 features on-board flash memory, allowing program updates to be downloaded via the network. The V300 connects to the V1000 through a high speed RS-485 network. The V1000 communicates with the system host via industry standard TCP/IP protocol over 10/100 Mbps Ethernet or the Internet. This architecture minimizes the impact on corporate LANs, by using only one TCP/IP address for every 32 sub-controllers and by handling low-level transactions on the RS-485 network. Datasheet